Physical and chemical properties of double-layers adhesive polymer film supplemented with 5% NaF

Jih, Myeong-Kwan; Lee, Sang-Ho; Lee, Nan-Young

doi:2021.59.4.204

J Korean Dent Assoc > Volume 59(4); 2021 > Article

ORIGINAL ARTICLE

The Journal of The Korean Dental Association 2021;59(4):204-212.
DOI: https://doi.org/10.22974/jkda.2021.59.4.001 Published online March 31, 2021.

5% NaF를 함유한 이중 고분자 접착필름의 물리·화학적 특성

지명관

, 이상호

, 이난영

조선대학교 치과대학 소아치과학교실

Physical and chemical properties of double-layers adhesive polymer film supplemented with 5% NaF

Myeong-Kwan Jih

, Sang-Ho Lee

, Nan-Young Lee

Department of Pediatric Dentistry, College of Dentistry, Chosun University

Correspondence: Sang-Ho Lee, Tel: +82-62-220-3865, Fax: +82-62-225-8240,
Email: shclee@chosun.ac.kr

Received: 12 October 2020 • Revised: 12 November 2020 • Accepted: 7 December 2020

Abstract

Objective
To improve the remineralization effect of fluoride adhesion film, we developed a double-layers adhesive film, and then evaluate its physical properties and fluoride-releasing ability.
Methods
The tensile strength, elongation, dissolution rate and fluoride-releasing capacity characteristics of the adhesive films were analyzed.
Results
There was no variation in thickness among the adhesive films. The tensile strength was highest in the polyvinyl alcohol (PVA) adhesive film and lowest in the pullulan adhesive film. The elongation rate was highest in pullulan film, followed by PVA-pullulan film and PVA film. Com-pared with the PVA adhesive film, the double-layer adhesive film exhibited higher fluoride ion emission for up to 60 minutes. Adhesive films had greater fluoride ion emission than fluoride varnish after 6 hours of application.
Conclusion
The tensile strength and elongation characteristics of double-layer adhesive films were superior to those of single-layer adhesive films. PVA-pullulan double-layer adhesive film had very high initial fluoride ion emission compared with PVA adhesive film and fluoride varnish. This increased fluoride ion emission may compensate for the disadvantages of fluoride varnish and PVA adhesive film. The above results indicate that the PVA-pullulan double-layer adhesive film has improved physical properties and fluoride-releasing capacity compared with conventional PVA adhesive film.

Key Words: fluorides; polyvinyl alcohol; pullulan